✨GETTING STARTED WITH 4D V2: IMPORTANT INSTALLATION TIPS
Physically setting up your Nanoleaf 4D V2
Attaching the Lightstrip
| ⚠️IMPORTANT | Do not twist or sharply bend the lightstrip at any point of the assembly. Make sure the back of your TV or monitor screen is free of dust, moisture, and oil before attaching the lightstrip. |
Stick the cardboard Guideline on the back on the TV to ensure the lightstrip is positioned correctly:
Next, Peel the tape off the Lightstrip, and adhere it around the back of your TV, at least 2” away from the edge. Press firmly along the length of the strip for at least 5 seconds to ensure a strong adhesion.
| ✨ TIP | Start with the end connected to the power cable on either side of the screen. |
Once the lightstrip is positioned and adhered to the TV, cut the remaining loose end carefully, avoiding any of the LED lights.
| ✂️ Once cut, the strip cannot be connected back together, so ensure you’re set up properly before cutting. |
Finally, connect the Lightstrip (USB-C) to the Controller.
Now, you're ready to pair and calibrate. See our 4D v1 installation tips and pairing guides for more help.
keywords: 4D v2 installation, 4D V2, 4D V2 installation, 4D V2 lightstrip set up.
Comments
0 comments
Article is closed for comments.