Integration Support | How-To > Razer Chroma – Nanoleaf Community & Knowledge Base

Applies to Razer Chroma Users & Light Panels

🆘 HOW-TO SET UP RAZER CHROMA WITH LIGHT PANELS

⚠️Before starting, make sure your Light Panels are already paired in the Nanoleaf App for iOS or Android.

Steps:

• Download the Windows Pairing Tool: 🔗 Nanoleaf Pairing Tool [3rd Party Site]
• Once downloaded, launch the Nanoleaf Pairing Tool and press Discover.
• Once discovered, you will be prompted to select the pairing button on the Nanoleaf controller

🪄Ta-da! Your panels will now work with the games listed here.

AUTO BRIGHTNESS SETUP: CANVAS USERS ONLY

The Auto Brightness feature uses the Canvas’ built-in ambient light sensor to adjust your light brightness based on your room’s lighting.

Available for users with:

• Nanoleaf App version 3.3.0 or higher

• Canvas firmware version 1.2.0 or higher

— — —

Before You Start

✅ Make sure your Canvas is not in direct sunlight
✅ If needed, close the curtains so the room has natural but indirect lighting
✅ Avoid any bright artificial lights nearby

— — —

How to Set Up Auto Brightness

• Open the Nanoleaf App and go to the Dashboard
• Tap the ⚙️ (gear icon) in the top right
• Scroll down and select Auto Brightness

The app will begin calibration, this takes about 3–5 minutes. Once done, Auto Brightness will be active!

💡 Keep your phone near the Canvas and avoid turning lights on/off, moving panels, or changing lighting in the room during this time.

Want to turn it off? Just repeat the steps above and toggle Auto Brightness off.

Related to