Wellness | Devices > 6-in-1 LED Light Therapy Wand Setup & Troubleshooting – Nanoleaf Community & Knowledge Base

The 6-in-1 LED Light Therapy Wand is a portable, all-in-one skincare tool for brightening, calming, and revitalizing skin. It is not a smart device and does not connect to an app.

GETTING STARTED

This rechargeable wand combines light therapy, temperature control, and vibration to help personalize every treatment.

wand 1.png

This wand includes a 2500mAh built-in battery and charges via USB-C in about 3.5 hours. Wait until it fully charges before first use. Do not use it while charging.

— — —

CONTROLS & BUTTONS

The Wand keeps things simple with just a few buttons.

• Power Button: Hold for 2 seconds to turn ON or OFF.
• Mode Button: Short press to choose your treatment mode (each treatment runs for 4 minutes with a beep at the 2-minute mark).
• Intensity Button: Adjusts the strength for modes that support intensity control (START LOW!). Choose from 3 levels.
• Charging Port: Plug in with the included charging cable. Only use the cable that comes with the device.

wand 2.png

— — —

BATTERY INDICATORS

TIP | Charge fully before first use for best performance.

wand - low battery2.png — Low Battery: The 3 LEDs cycle from top to bottom and beep in 5 second intervals

wand - charging.png — Charging: The 3 LEDs cycle from bottom to top.

wand - charged.png — Fully Charged: All 3 LEDs stay on when plugged in and fully charged. Full charged in four (4) hours.

— — —

HOW-TO
6-in-1 LED Light Therapy Wand

First, clean your face before each use 🫧 | (Optional) Apply your favorite serum or moisturizer.

Then, hold Power for 2 seconds to turn on.

Select your mode using the Mode button.

Adjust intensity (if available).

Glide the wand gently over your face or focus on target areas.

wand 4.png — **TIP |** Move the wand slowly and evenly across your skin for best results.

The wand will beep at two (2) minutes and end at four (4) minutes. To continue, select the next mode or power off.

🌎Video in English Only.
— — —

Troubleshooting

• Not charging? Ensure it is plugged into a want and the charging cable properly.

• Trouble with Repair or Cooling Mode? After using Repair or Cooling mode once, you can’t select them again. The Repair and Cooling treatment mode uses cooling technology that requires a 4-minute cooldown to protect the device. During this time, those two modes are unavailable, but you can still use all other modes. After 4 minutes, Repair and Cooling will be ready again.

📖: User Guide (Multilingual)

🆘 Need help? Submit a ticket using the form: Hardware Support

Related to

Related articles