The Red Therapy Light Panel is not a smart device and does not connect to an app. It features built-in controls that let you easily adjust intensity levels and set a treatment timer (10–30 minutes), allowing for simple, effective use without needing your phone or any other external device.
GETTING STARTED
This panel is designed for face and body use, helping promote a natural glow, relaxation, and recovery. In the box, there should be four (4) pieces:
— — —
DEVICE BUTTON GUIDE
Your panel has three (3) simple buttons and a small display screen.
#1 - Display Screen: Shows your countdown timer and current intensity level.
#2 - Buttons:
• Power: Press and hold for 2 seconds to turn on/off. Press once to start your session.
• Timer: Cycle between 10 / 15 / 20 / 25 / 30-minute sessions.
• Intensity: Choose from 4 levels (L1 to L4), with L4 being the strongest.
Press Power again to confirm your intensity selection*.
#3 - Power Port. Located on the side, connect the included USB-C charger here. Always keep the panel plugged in while in use.
Power Requirements
• Input: 15 V DC (supplied charger only)
• Connection: USB-C
• Run Time: Up to 30 minutes per session
⭐Important | Use only the charger included in the box. Using another charger could damage your device or void your warranty.
*Devices manufactured following our initial batch launched do not require the power button to be pressed again. Treatment will begin immediately [Device ID Batch Number TBC]
— — —
HOW-TO
Red Light Therapy Panel Setup
⚠️ To use the product, it must be plugged into a power source during use.
After unboxing everything, attach the panel to the table stand using the groove or bracket. Then, plug in the USB-C charger to a wall outlet and connect to the panel.
Next, adjust the panel’s angle so it faces your target area (face or body).
TIP | 🫧Wash your face first if target the face.
Then:
• Put on the provided eye protection glasses.
• Hold the Power button for 2 seconds to turn on.
• Select your preferred intensity and timer, then press Power again to begin*.
TIP | Start low (L1 or L2) and gradually increase as your skin adjusts.
*Devices manufactured following our initial batch launched do not require the power button to be pressed again. Treatment will begin immediately [Device ID Batch NumberTBC]
Use your panel for 10–30 minutes, 3–5 times a week based on your goals:
• 10 minutes: Daily maintenance or skincare boost
• 30 minutes: Deeper recovery or post-workout support
The built-in timer lets you easily choose your session length.
TIP | Stay consistent! Regular use delivers the best results.
— — —
Troubleshooting
• Device not turning on? Ensure it is plugged into a light source and the USB-C is plug into the panel properly.
• Uneven light output? Check for debris or damage on LED surface.
— — —
📖: User Guide
🆘 Need help? Submit a ticket using the form: Hardware Support
Comments
0 comments
Article is closed for comments.