How-to | Device Reset > Lightstrips & String Lights

🆘RESETTING INSTRUCTIONS FOR VARIOUS LIGHSTRIPS & STRING LIGHTS

Applies to Nanoleaf Essentials Matter & 'Non-Matter' Lightstrips/String Lights [Wifi-enabled, Thread-enabled, Matter over Thread, Matter over Wifi, HomeKit)

⚠️ A factory reset erases your pairing and network info. You’ll need to set the device up again afterward.

Smart Matter Lightstrips & Smart Lightstrip [HomeKit] | Discontinued

Before resetting, delete the Essentials Lightstrip from the Nanoleaf App. 

To reset: Press and hold the Power and Brightness Up (+) buttons at the same time for five (5) seconds. (Doing them one after the other won’t work!) You’ll see the strip flash white three (3) times which means the reset worked, and it’s ready to pair again.

📽️: Video

— — —

Multicolor Lightstrips | Multicolor HD Lightstrips | (Holiday} String Lights) | Floor Lamp | Rope Light | 

To reset your Lightstrip/String Lights, hold the power button on the controller for 10 seconds while the device is plugged in and powered on. The lightstrip/string light will flash red three (3) times after a successful reboot.

After this reset, starting the pairing process again.

 

Outdoor String Lights & Permanent Outdoor Lights

To reset your Lightstrip, hold the power button on the controller for 10 seconds while the device is plugged in and powered on. The lightstrip will flash red three (3) times after a successful reboot.

After this reset, starting the pairing process again.